Dual band transmitter power amplifier for the LF ( 2190m ) and MF ( 630m ) bands

home made enclosure 25 x 24.5 x 12cm

band module for the 2190m band is shown installed

I've recently finished building another amplifier for my transmitting setup for the 2190m/136KHz and 630m/475KHz bands. It is a switching amplifier design based on Class 'E' topology, using four IRF640N  MOSFETs in parallel. To allow operation on both bands I constructed the output tuning and matching circuit for each band as a removable module; changing the frequency band of operation just requires installing the appropriate module. I have also fitted a RF voltage sensed automatic antenna changeover circuit.
In use the amplifier runs only slightly warm. Each MOSFET is mounted on a separate 4.4degC/W heat-sink, two cooling fans are running and there is ample ventilation. So my work on the thermal aspects of the design was worth the effort. By using 4 MOSFETs in parallel there is very little heat to be dissipated anyway as their combined 'on-resistance' is extremely low. Amplifier efficiency is about 83%.
I was very pleased to get a reception report of my signal on the 630m band from Bantry, south-west Ireland, ( distance 2085 kms ), as well as reports from Greece and Spain.
My future plans are to paint the front panel of the enclosure, and make a hinged top cover.
I can provide the circuit diagram on request by email.